Kegel FLEX 17-5801 Operator's Manual page 47

1. While in the operating position, stand facing the lane machine from the cleaner
compartment side and push the lid all the way away from you.
2. Standing in rear of the machine, lift the cleaner lid assembly up and out of the rear
guide opening. Pull the back of the lid towards you and lift the rear portion up and
out of the guide openings as well.
Front Cover Removal
To remove the front cover, simply unfasten the 4
screws that secure the top of the cover, and remove
from the attaching pins located on the bottom.
Rear Cover Removal
With the machine in the up-right
transport position, locate the two
screws that are on the inside front
panel and below the buffer brush
assembly as shown to the right.
After removing these, set the
machine down into the operating
position.
35
Locate the single mounting screw under the
cleaner splash guard and above the cleaner
supply tank, as shown in the image to the left.
Next, remove all four of the transport casters
including the attaching hardware and unplug the
wiring for the tank lights then set aside for
reassembly.