Kegel FLEX 17-5801 Operator's Manual page 104

This adjustment should be monitored and checked.
LDS STOPS MACHINE is the primary stopping function for cleaning or dusting. The machine
should travel far enough for the squeegee to clear the tail plank when adjusted. Increasing
the value will cause the machine to travel farther.
When the LDS stops the machine the touchscreen buzzer will
sound. If the Sensor stops the machine there is no sound.
Use the increase and decrease value buttons to make
adjustments. Any change to the value sets the data
automatically.
If this value is set too high it will show up in the Monitor
Screen, the value left over in LDS Stops Machine would be a good amount to adjust this
function by.
data automatically.
92
The Sensor on the WALKER or FLEX located on the Squeegee
assembly is used to stop the machine any time needed. It
works when the Sensor goes passed end of the Pindeck.
When the machine is stopped by the Sensor there is no
buzzer sound from the touchscreen. The adjustment is in
increments of 0.30 of an inch (7.62 mm) for fine adjustments
(available on the Walker only).
The number displayed in the screen to the left will refer to
the distance from the tail plank the duster will begin to lift
off of the lane. This feature prevents the cushion roller from
dropping off the tail plank when reaching the end of the
lane.
To change this distance, use the + or - buttons to adjust.
Once the value has been changed, the program accepts the