Kegel FLEX 17-5801 Operator's Manual page 146

The machine will clean and condition 6 lanes while adjusting its speeds using pattern 31
(calibration pattern). Press Start Speed Adjust and the machine will start operating. The
machine sets 10 IPS first for the Forward and Reverse settings.
The number to the left of Analog Speed Value is the Step Number; 1 is 10 IPS Forward and 2
is 10 IPS Reverse, 3 is 14 IPS Forward and 4 is 14 IPS Reverse. This number sequence
continues through all the speeds.
Warning: ODD numbers are for FORWARD
not run the wrong step number in forward or reverse travel.
The following list shows the Inches per Second settings and DC voltages for the machine
speeds:
1. 9-10 IPS
2. 13-14 IPS
3. 17-18 IPS
4. 21-22 IPS
5. 25-26 IPS
6. 29-30 IPS
TECHNICAL
These six speeds will need to be adjusted through the touchscreen. High speed and
speeds for approach travel are all self-adjusting and do not need any adjustment.
Bumper Wheels
Located in the rear of the Walker are two Bumper Wheels. These wheels will help seat the
machine on the lane by kicking the rear end around if the machine does not enter the lane
squarely. The overall width of the machine from outside of bumper wheel to bumper wheel
should be between 59-½ to 60 inches (152.4 cm), depending on foul lights and lane
installation. Adjust the height between the bottom of the wheel and the surface of the
approach to about 1-½" (3.81 cm).
134
The number to the right of Analog Speed Value is the
adjustment value. Below these numbers we show
the TARGET SPEED and the RUNNING SPEED. The
higher speeds may need to be run a couple of times
to properly set the adjustment.
To skip to the higher speeds, press where it says
Analog Speed Value. The TARGET SPEED button will
change to INC SPEED, then press where it says INC
SPEED to change the step number.
travel and EVEN numbers are REVERSE travel. Do
9.24VDC
11.54VDC
14.21VDC
16.82VDC
18.91VDC
21.70VDC