Kegel FLEX 17-5801 Operator's Manual page 37

NOTE: Running two warm-up lanes will allow the Transfer Brush and Buffing Brush to be
replenished with conditioner and return to a constant refreshed state. This will help
prevent the first lane and pair from being different (drier) than the rest. This is critical for
league and tournament play conditions. Kegel has recommended this procedure to be
done with every machine we have produced.
To override the preset pattern showing in the STARTING LANE
screen, press the PROGRAM OVERRIDE button (in the bottom
center of the screen) and the display will change. A password
will need to be entered into the screen to continue.
not a 3 for the left digit).
The upper limit is 30, which is the number of total patterns stored in the program. To
advance from pattern 29 to 30 you will need to change the right digit to 0 before you can
change the left digit to 3. Program 31 is a READ ONLY calibration program that cannot be
accessed from the Program Override menu.
After you have chosen the starting lane, press GO TO ENDING
LANE to advance to the screen on the left. Choose the ending
lane the same way as the starting lane.
You can still choose to do a Pattern Override
Pair function from the ending lane screen.
After you have chosen the last lane for this operation, press START MACHINE in the lower
right corner of the display.
The screen will change to a confirmation screen for your review to ensure all information
has been entered correctly.
25
After you enter a valid password, the screen will allow you to
choose your desired pattern number. The name of the
pattern will also appear above the pattern number. After
choosing the desired pattern press GO TO STARTING LANE.
When entering the pattern number each digit must be
adjusted. The left digit will go no lower than 0 and no higher
than 3, the right digit will go from 0 to 9 (as long as there is
and set the Burn