Kegel FLEX 17-5801 Operator's Manual page 109

4. Place the cap and hose assembly on top of the new bottle and push
firmly on the outside portion of the cap to attach it to the stem.
Even though the protective cap is in place, be careful to not press
the center button during this process, you will have a sticky mess to
clean up! If replacing the entire cap, remove the protective cap after
installing the actuator cap and press down to break the plastic on
the actuator button.
5. After installing, too ensure proper flow, go to the output menus and with the tip
assembly in disposable cup, continuously press the Pindeck treatment output
key until the air is out of the lines and a steady flow is present.
After replacing the can, be sure to reset the number of lanes left in the can by pressing
COUNTER RESET from the Pindeck Treatment screen in Main Menus.
97