Kegel FLEX 17-5801 Operator's Manual page 30

be a BRUSH UP error displayed. If the brush up switch sticks closed when it should
be open it will give a BRUSH DOWN error.
10. When the oil distance has been reached the machine will shift into high speed and
continue to travel toward the pin deck. As the machine approaches the pin deck the
last squirt distance will turn off the cleaner pump and the moving heads will park. At
the same time the machine will down shift to low speed to reduce its momentum
into the pin deck.
11. When the machine enters the pin deck, the duster wind-up motor will turn on at its
pre-determined distance and start to wind up the cloth (to raise the duster). The
duster up switch's normally open contacts will close to turn off the duster wind-up
motor. If the contacts do not close there will be a DUSTER WINDUP error displayed.
12. There are two ways to reverse the Walker or Flex. In this scenario, the LDS sensor
stops the machine and the alarm buzzer will sound to alert the operator.
13. The other option is the Stop by Sensor. The machine will be signaled to stop when
the Sensor goes passed the tail plank and trips before the LDS. Using both functions
to stop forward travel creates a back-up method for the stopping the machine.
14. When the machine reaches its travel distance and comes to a stop, the squeegee will
proceed to lift up and stop when the squeegee up switch normally open contacts
close. If the contacts do not close, a SQUEEGEE UP error will be displayed.
15. If the Pindeck Treatment function is disabled, the machine will then start traveling in
reverse and stop after moving 14 inches. The squeegee will lower and the machine
will go forward again and stop, then lift the squeegee. This function helps to remove
drips off the squeegee blades. If the Pindeck Treatment function is enabled the
machine will start moving in reverse until the cleaner head assembly is line with the
2-3 pin deck spots then drop the duster.
fine-tuning. (refer to Chapter 3 for more information)
16. The machine will then start up the moving head to apply the Pin Deck Treatment.
After application of Pindeck Treatment the machine will wipe it onto the Pindeck and
stop with duster on back row of spots then duster will lift.
17. The machine will now travel in reverse, turn the vacuum off, and run the cleaner
pump in reverse for 1 second to help reduce pressure on the cleaner tip.
18. As the machine travels in reverse at high speed the lane distance sensor is counting
inches traveled and is also monitoring the movement of the machine. If travel is
interrupted, a REVERSE TRAVEL error will be displayed.
19. The brush will begin buffing at the pre-determined distance as the Walker travels in
reverse. The oil head will start back up again when it reaches the first reverse load
distance.
18
This reverse distance can be adjusted for