Table of Contents
Advertisement
Remove screw
i925-411
www.powercommander.com
PCIII harness
PCIII harness
1
Remove the main seat.
2
Prop the front of the fuel tank up.
3
Install the PCIII in the tail section on top of
the tool kit (Fig. A)..
4
Route the PCIII harness along the right hand
side of the bike.
5
Remove the screw securing the tail section to
the subframe so that the PCIII harness can be
routed underneath the tab (Fig. A).
6
Continue routing the PCIII harness down the
right hand side of the frame towards the
engine (Fig. B).
7
Continue routing the PCIII harness down the
right side of the bike and on the inside of the
upper frame spar (Fig. C).
2005-2007 KTM Superduke - PCIII USB - 2
Advertisement
Table of Contents
Need help?
Do you have a question about the POWER COMMANDER III and is the answer not in the manual?
Questions and answers