Siemens SINAMICS G120 Installation Manual page 64

Connecting
4.2 Connecting the line and motor cable at the converter
Braking resistor connection
Use the rubber cable gland as shown in the right-
hand figure for connecting the braking resistor.
Using a sharp knife, cut the cap of the cable gland
corresponding to the diameter of the connection ca-
ble of the braking resistor and establish the connec-
tions.
Connect the braking resistor at the R1 and R2 termi-
nals.
An optional shield plate is available as strain relief for
the connection cable of the braking resistor.
62
Top shield plate - FSD ... FSG (Page 117)
Hardware Installation Manual, 01/2020, A5E33294624B AL
Power Module PM240-2