Siemens SINAMICS G120 Installation Manual page 42

Installing
3.4 Mounting the Power Modules
Mounting the shield plate, FSG
Procedure
Proceed as follows to mount the shield plate:
● If you are using a Brake Relay to control a motor holding brake, then mount the Brake
Relay at the rear of the shield plate.
● Secure each side part to the shield plate with two screws
● Fasten the EMC connecting bracket to the shield plate with four screws
● Screw the shield plate to the converter together with the side parts and EMC connecting
bracket using four screws
You have mounted the shield plate.
40
Mounting and connecting the brake relay (Page 143)
②
①
.
Hardware Installation Manual, 01/2020, A5E33294624B AL
②
.
Power Module PM240-2