Introduction - Siemens SINAMICS G120 Installation Manual

Power modules, ip20 / push-through technology (pt)
Hide thumbs Also See for SINAMICS G120:
Table of Contents

Advertisement

Introduction

Overview
The Power Modules belong to the modular family of SINAMICS G120 converters. A modular
converter comprises a Control Unit and a Power Module.
Depending on the power rating in frame sizes FSA ... FSG, the following Power Module
versions are supplied:
• 1 AC 200 V
• 3 AC 200 V
• 3 AC 400 V
• 3 AC 690 V
Control Units for the Power Modules
You can operate the Power Modules with a Control Unit from one of the following listed
families:
● CU230P-2
● CU240B-2
● CU240E-2
● CU250S-2
For Power Modules FSA ... FSC, you require a Control Unit with firmware version V4.4 or
higher.
For Power Modules FSD ... FSF, you require a Control Unit with firmware version V4.7 HF8
or higher.
For Power Modules FSG, you require a Control Unit with firmware version V4.7 SP9 or
higher.
Note
Commissioning the converter
You must first commission the converter before you can use it. Commissioning is described
in the Operating Instructions of the relevant Control Unit.
Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
0.55 kW ... 4 kW
0.55 kW ... 55 kW
0.55 kW ... 250 kW
11 kW ... 250 kW
Manuals for your converter (Page 163)
for line voltages from 1 AC 200 V ... 240 V
for line voltages from 3 AC 200 V ... 240 V
for line voltages from 3 AC 380 V ... 480 V
for line voltages from 3 AC 500 V ... 690 V
2
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics pm240-2

Table of Contents