Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual page 46

AppDirector Installation and Maintenance Guide
Platform Installation
5. Power on the platform. The PWR and SYS or SYS OK LED indicators on the front panel light up.
The platform starts up. After approximately a minute, the Startup Configuration window is
displayed.
6. In the Startup Configuration window, provide the required information for the IP address, IP
subnet mask, Port Number, for the management port, and Default router IP address
parameters, and press Enter for each of the remaining settings. The platform reboots after the
last parameter is defined. Press Enter to accept default values.
If no configuration is entered within 30 seconds, the platform applies the following default
configuration:
— IP Address: 192.168.1.1
— IP subnet mask: 255.255.255.0
— Port number for management. The port number depends on the platform. For OnDemand
Switch platforms, the default is
7. If the start-up configuration screen does not appear, do the following:
a. Wait for the prompt
b. Type and press Enter.
login
c. Enter the username and password.
Note: Contact your Radware support representative for the default user name and password.
d. To view the current IP interface setting, enter the following:
net ip-interface get
e. To add/modify/delete the existing IP Interface, enter the following:
net ip-interface add/modify/delete
or enter: net ip-interface help to see the command options.
46
.
G-1
.
<ProductName>>
Document ID: RDWR_APD_IG_1304