Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual page 11

The following figure shows the caution label that is attached to Radware platforms with dual power
supplies.
Figure 1: Electrical Shock Hazard Label
DUAL-POWER-SUPPLY-SYSTEM SAFETY WARNING IN CHINESE
The following figure is the warning for Radware platforms with dual power supplies.
Figure 2: Dual-Power-Supply-System Safety Warning in Chinese
Translation of Dual-Power-Supply-System Safety Warning in
This unit has more than one power supply. Disconnect all power supplies before maintenance to
avoid electric shock.
SERVICING
Do not perform any servicing other than that contained in the operating instructions unless you are
qualified to do so. There are no serviceable parts inside the unit.
HIGH VOLTAGE
Any adjustment, maintenance, and repair of the opened instrument under voltage must be avoided
as much as possible and, when inevitable, must be carried out only by a skilled person who is aware
of the hazard involved.
Capacitors inside the instrument may still be charged even if the instrument has been disconnected
from its source of supply.
GROUNDING
Before connecting this device to the power line, the protective earth terminal screws of this device
must be connected to the protective earth in the building installation.
LASER
This equipment is a Class 1 Laser Product in accordance with IEC60825 - 1: 1993 + A1:1997 +
A2:2001 Standard.
FUSES
Make sure that only fuses with the required rated current and of the specified type are used for
replacement. The use of repaired fuses and the short-circuiting of fuse holders must be avoided.
Whenever it is likely that the protection offered by fuses has been impaired, the instrument must be
made inoperative and be secured against any unintended operation.
Document ID: RDWR_APD_IG_1304
AppDirector Installation and Maintenance Guide
Chinese:
11