Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual page 31

Figure 26: OnDemand Switch 2 Front Panel
Table 5: OnDemand Switch 2 Front Panel Connectors and Indicators
Feature Label/Description
SFP GbE ports for traffic or management. The platform supports four (4) SFP
ports.
LEDs:
•
•
RJ-45 GbE ports for traffic or management. The platform supports twelve (12)
GbE ports.
LEDs:
•
•
Power button. Turns power on and off. Pressing the button for 1 to 4 seconds
causes a graceful shutdown of the system, thus preserving system integrity.
Pressing the button for more than four (4) seconds causes the hardware to
power down.
Reset button. Resets the platform.
USB port for recovery and file transfer.
Management ports. The platform supports two RJ-45 10/100/1000 Ethernet
ports, which are for management only.
LEDs:
•
•
RS-232 DE-9 port for out-of-band management.
Status LEDs:
•
•
•
Figure 27: OnDemand Switch 2 (with Single Power Supply) Back Panel
Document ID: RDWR_APD_IG_1304
ACT—Flashing indicates activity.
LINK—Green indicates 1000 Mbit/s.
ACT—Flashing indicates activity.
LINK—Green indicates 1000 Mbit/s. Yellow indicates 10 or 100 Mbit/s.
ACT—Flashing indicates activity.
LINK—Green indicates 1000 Mbit/s. Yellow indicates 10 or 100 Mbit/s.
PWR—Green indicates proper power supply operation. Red indicates a power
supply failure or a failure in one of the dual power supplies or power supply
cables or power source.
FAN—Green indicates normal operation. Red indicates that one or more fans
are not operating.
SYS OK—Green indicates normal operation. Red indicates that the platform
is booting. Red or alternating red and green indicates a warning (for
example, the temperature is high, but still in the allowed range).
AppDirector Installation and Maintenance Guide
Platforms
31