Recovery With Non-Bootable Usb Or Compact Flash Device - Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual

4. Run the following command:
mkusb.bat <Drive letter associated with your USB device>:
Note: The trailing colon (
5. Follow the instructions displayed on the console. The batch file formats the UMS device and
copies the required files into it. Confirm the steps of the batch job by pressing Enter. The new
volume label after formatting is not essential, so you may leave it empty by pressing Enter.
6. When the USB device is ready, copy the TAR application file to the root directory of the USB
device.
7. Unplug the USB device from your host computer.
8. Insert the USB device into the OnDemand Switch.
9. Turn on the OnDemand Switch. The OnDemand Switch boots from the USB. When successful,
the application installation process runs automatically and displays progress information on the
console.
10. When the primary installation is completed, remove the USB device from the OnDemand Switch.
The OnDemand Switch will prompt and wait for this confirmation.
11. Press Enter to confirm the USB is out of the OnDemand Switch.
12. When prompted, enter the license, which you obtain from Radware Technical Support.
13. Enter the password.
Note: You can generate the password from:
http://www.radware.com/Portal/Customer/passwordGenerator.aspx?id=4294967329
14. When prompted, restart the OnDemand Switch.
Note: In case of failure, an appropriate message is printed to the terminal.

Recovery with Non-bootable USB or Compact Flash Device

This section describes OnDemand Switch recovery (reinstalling the software) with a non-bootable
UMS device or a compact flash device. Prerequisites include:
• An OnDemand Switch Recovery executable file.
Note: You can obtain the recovery file from www.radware.com. Log in if prompted.
Under My Updates > Software Releases, the set of products and software downloads for
which you have a license displays. For the required release version and platform select
Download Software, and download the relevant file to a server within your organization that is
accessible using FTP or TFTP.
• A valid TAR application file for the relevant version of your product.
You can obtain the TAR file from
https://www.radware.com/content/support/software/statusmatrix/default.asp?_v=statusmatrix.
Document ID: RDWR_APD_IG_1304
) is required (for example:
:
AppDirector Installation and Maintenance Guide
Troubleshooting and Recovery
).
mkusb.bat k:
61