Dc Power Supply Connectors - Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual

AppDirector Installation and Maintenance Guide
Platforms
Figure 31: OnDemand Switch 3 Back Panel
Feature Description
Dual power The socket to which the power cable is connected.
supply sockets
CompactFlash Insertion point for compact flash card.
Ground screws Screws to ground the platform chassis to the rack. Typically, 2U units have two
ground screws.

DC Power Supply Connectors

Use a 12-gauge insulated copper DC-input cable for the connection to each DC power supply.
Note: The DC connection cable should have a ring terminal (lug) type RV5-6 or equivalent (for M6
or 1/4" stud size) at one end and a ring terminal (lug) type RVS5-4 or equivalent (for M4 or #8 stud
size) at the other end.
Figure 32 shows the DC connector for the following platforms:
• OnDemand Switch VL single and dual DC power supply platform
• OnDemand Switch 1 single DC power supply platform
• OnDemand Switch 2 single DC power supply platform
34
Table 8: OnDemand Switch 3 Back Panel
Document ID: RDWR_APD_IG_1304