Uploading Configuration Files; Downloading Configuration Files Using Cli - Radware AppDirector OnDemand Switch VL Installation And Maintenance Manual

AppDirector Installation and Maintenance Guide
Maintenance and Upgrade

Downloading Configuration Files Using CLI

If you are downloading a configuration file using CLI and SNMPv3, you cannot download to a
platform supporting only SNMPv1.
To download a configuration file using CLI
 Enter the following command:
system config download <File> <Server IP address>
Note: You can display the existing configuration using CLI using the command
system config immediate
Then, you can copy the configuration file text to a text editor and save it as you require.

Uploading Configuration Files

Note: The configuration file of a platform that contains SNMPv3 users with authentication can only
be used by the specific platform that the users configured. When you upload a configuration file to
another platform, passwords need to be re-entered, since passwords (of SNMPv3 users) cannot be
exported from one platform to another. Therefore, there must be at least one user in the user table
(to be able to change the password) in order to upload a configuration to another platform.
Upload Mode
With WBM and APSolute Vision, you can upload a configuration file to a platform using one of the
following modes:
• Append Commands to Configuration File
• Append Commands to Configuration File with Reboot
• Replace Configuration File
Append Commands to Configuration File
Using the Append Commands to Configuration File mode, it is possible to add parts of a
configuration into a platform.
The Append Commands to Configuration File method is supported using the following management
options:
• By pasting the configuration into the terminal using the command
system config paste start
system config paste stop
• By uploading the file using Web Based Management and selecting the option Append
Commands to Configuration File in the Upload Configuration File to Device window.
• By executing the terminal command
Using the Append Commands to Configuration File method, you can only append commands that do
not require rebooting the platformfor the commands to take effect, for example, defining a Server or
adding an IP Interface.
If a command that requires reboot is pasted or uploaded to the platform using the Append
Commands to Configuration File method, the command is not implemented.
54
.
. Once all the data is pasted, you must enter the command
.
system config upload append
.
Document ID: RDWR_APD_IG_1304