Installing The Electronic Key Encoder And Utility Device - Kaba Saflok SAM RF Operation Manual

®
SAM RF Operations Manual
Section 2: Installing the SAM RF System

2.6 Installing the Electronic Key Encoder and Utility Device

After the SAM RF software and the USB Drivers are installed, you will need to install is the electronic key
encoder that connects to your PC using its USB cable. The installation of the electronic key encoder will
also allow the utility device to communicate with the PC. When the utility device sits in the base of the
electronic key encoder, its batteries recharge for operations at the InSync™ locks throughout your
property.
SAM RF System USB Cable Connections
Electronic
Key Encoder
1. Plug the power source into an electric socket in the wall or a power strip, then plug the power source
into the key encoder base.
2. Plug the electronic key encoder USB cable into the base of the electronic key encoder and connect
the other end to the USB port of your PC.
3. Connect the USB cable between the electronic key encoder base and the utility device.
© SAFLOK
USB Cable to PC
T o C ompt er
USB Cable from
Utility Device to
Encoder Base
31
Utility Device
P owerC o r d
Power Cord
WL 12/19/2007