Get Lock Info - Kaba Saflok SAM RF Operation Manual

®
SAM RF Operations Manual
Section 6: Locks

6.4 Get Lock Info

The SAM RF System allows you to retrieve information about a lock's identity, current date and time, and
current battery voltage status using the utility device. This feature is an important part of your regular
maintenance routine, including lock battery replacement and making certain that the lock's clock is
properly synchronized.
1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet
and the USB cable between them is properly attached (see Section 2.5 "Installing the Key Encoder
and Utility Device").
2. To initialize the utility device to get lock
information, point to the Utility Device pull-down
menu and select Get Lock Info.
Note: You must keep all USB
cables connected between the
electronic key encoder base, the
utility device and the PC while the
key image spins on the PC screen.
3. The PC screen will display, "The write operation was
successful!" Click OK.
4. Disconnect the USB cable located on the
back left hand side of the electronic key
encoder base. The USB cable must
remain attached to the top of the utility
device. Remove the utility device with the
USB cable attached and take it to the lock.
The utility device screen will display, "Get Lock Info."
5. Connect the USB cable on the utility
device to the lock's receptive port
located underneath the bottom of the
lock. You will need to remove the
rubber cover on the lock's receptive
port to insert the USB cable. Be sure
the connectors of the USB cable and
the lock's receptive port match up.
© SAFLOK
Utility Ver.
Get Lock Info.
152
WL 12/19/2007