Reading The Guard Check Keys - Kaba Saflok SAM RF Operation Manual

®
SAM RF Operations Manual
Section 5: Keys
5.14 Reading the Guard Check Key
When the key is returned, it should be read to view or print the report of where the key was used. The
report will show the last 25 common access locks in which the key was used.
Note: The maximum number of duplicate keys is 64. After you have made 64 duplicate keys, you must
start over by making a new key for that level.
1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet
and the USB cable between them is properly attached (see Section 2.5 "Installing the Electronic Key
Encoder and Utility Device").
2. Insert the Guard Check key into the electronic encoder.
3. Point to the Keys pull-down menu and
select Read.
Note: If the key is not currently in the
electronic key encoder, the PC will display
an error screen until you insert a key into
the electronic key encoder.
Note: You must keep the USB cable
connected between the electronic key
encoder base and the PC while the key
image spins on the PC screen.
4. At the Key Read screen, you will see the key type,
who the key was assigned to, the status of the key
and who made the key. Click on Report.
© SAFLOK
118
WL 12/20/2007