Installing The Usb Driver Software - Kaba Saflok SAM RF Operation Manual

®
SAM RF Operations Manual
Section 2: Installing the SAM RF System

2.5 Installing the USB Driver Software

After the SAM RF system software is installed, you must install is the CP2101 USB driver software.
Important: Do not connect the key encoder and utility device until all software is installed.
Note: Keep the default settings as you install the USB driver software unless you are directed otherwise
by SAFLOK technical support.
Important: Do not connect the key encoder and utility device until all software is installed.
1. With the CD still in the CD-ROM, ....explore
the CD-ROM drive.
2. Go to your CD-ROM drive and double click
on the CP2101 Custom Install icon.
3. Click Next at the bottom of the CP2101
Custom Setup Warning PC dialog box.
© SAFLOK
27
WL 12/19/2007