WEG CFW701 User Manual page 26

Table 3.1: Configuration of the switch for the analog input and output signals selection
Input/ S1 Switch
Signal
Output Settings
Voltage S1.2 = OFF
AI1
Current S1.2 = ON
Voltage S1.1 = OFF
AI2
Current S1.1 = ON
AI3 Current
Voltage S1.3 = ON
AO1
Current S1.3 = OFF
Voltage S1.4 = ON
AO2
Current S1.4 = OFF
(*) Factory setting.
NOTE!
Settings of the S2 switch:
S2.1 = ON and S2.2 = ON: RS-485 is ON.
„
S2.1 = OFF and S2.2 = OFF: RS-485 is OFF.
„
The factory default for the S2.1 and S2.2 switches are OFF.
Other combinations of switch S2 are not allowed.
Follow instructions below for the proper installation of the control wiring:
1. Wire gauge: 0.5 mm
2. Maximum tightening torque: 0.50 N.m (4.50 lbf.in).
3. Use shielded cables for the connections in XC1 and run the cables separated from the
remaining circuits (power, 110 V / 220 Vac control, etc.), according to
on page 22. If control wiring must cross other cables (power cables for instance), make
it cross perpendicular to the wiring and provide a minimum separation of 5 cm (1.9 in) at the
crossing point.
Refer to Item 3.2.6 Cable Distances on page
Signal
Range
0...10 V P0233 = 0 (direct reference) or 2 (reverse reference).
(*)
(*)
-10...10 V P0233 = 4
0...20 mA P0233 = 0 (direct reference) or 2 (reverse reference).
4...20 mA P0233 = 1 (direct reference) or 3 (reverse reference).
0...10 V P0238 = 0 (direct reference) or 2 (reverse reference).
(*)
(*)
-10...10 V P0238 = 4
0...20 mA P0238 = 0 (direct reference) or 2 (reverse reference).
4...20 mA P0238 = 1 (direct reference) or 3 (reverse reference).
- 0...20 mA P0243 = 0 (direct reference) or 2 (reverse reference).
- 4...20 mA P0243 = 1 (direct reference) or 3 (reverse reference).
0...10 V P0253 = 0 (direct reference) or 2 (reverse reference).
(*) (*)
0...20 mA P0253 = 0 (direct reference) or 2 (reverse reference).
4...20 mA P0253 = 1 (direct reference) or 3 (reverse reference).
0...10 V P0256 = 0 (direct reference) or 2 (reverse reference).
(*) (*)
0...20 mA P0256 = 0 (direct reference) or 2 (reverse reference).
4...20 mA P0256 = 1 (direct reference) or 3 (reverse reference).
(20 AWG) to 1.5 mm² (14 AWG).
²
22, for the proper cable distances.
Installation and Connection
Parameter Settings
Item 3.2.6 Cable Distances
CFW701 | 21