WEG CFW701 User Manual page 32

The HMI supplied with the product can also be used for remote command of the inverter. In
this case, use a cable with male and female D-Sub9 (DB-9) connectors wired pin to pin (mouse
extension type) or a market standard Null-Modem cable. Maximum length of 10 m (33 ft). It is
recommended the use of the M3 x 5.8 standoffs supplied with the product. Recommended
torque: 0.5 N.m (4.5 lbf.in).
Use the keypad frame accessory to assembly the keypad on the panel door or control table
(see Section 7.2 ACCESSORIES on page
on page 144).
NOTE!
A list of parameters is supplied with the product, for additional information
on each parameter refer to the CFW701 programming manual available for
download on website: www.weg.net.
Keypad (HMI) and Basic Programming
38, or perform the drilling as shown in Figure A.5
CFW701 | 27