Electrical Installation - WEG CFW701 User Manual

Installation and Connection
Frame size E inverters with N1 option (CFW701E...N1...):
After fixing the inverter, install the upper Nema 1 kit on the inverter using the two M8 screws
„
provided with the product.
Let the minimum clearances specified in
for cooling. It is possible to assembly frame sizes A, B and C inverters with IP20 protection
degree (CFW701... 20...) side by side without lateral spacing, i.e., with the D distance presented
in Figure B.3 on page 176
Do not install heat sensitive components right above the inverter.
ATTENTION!
When arranging two or more inverters vertically, respect the minimum
„
clearance A + B
plate so that the heat rising up from the bottom inverter does not affect the
top inverter.
Provide conduit for physical separation of the signal, control, and power
„
conductors (refer to
Please refer to Figure B.3 on page 176
dissipated power at rated condition for surface and flange mounting is presented in
on page 156. Remove the drive mounting brackets for flange mounting. The protection degree
of the inverter outside the panel is IP55 for flange mounting. It is necessary to provide proper
seal for the opening where the inverter is installed to ensure the protection degree of the panel.
Example: sealing with silicone.
Please refer to Figure A.4 on page 144
power terminals.

3.2 ELECTRICAL INSTALLATION

DANGER!
The following information is merely a guide for proper installation. Comply
„
with applicable local regulations for electrical installations.
Make sure the AC power supply is disconnected before starting the
„
installation.
DANGER!
Les informations suivantes constituent uniquement un guide pour une
„
installation correcte. Respectez les réglementations locales en vigueur pour
les installations électriques.
Vérifiez que l'alimentation secteur CA est débranchée avant de commencer
„
l'installation.
10 | CFW701
Figure B.3 on page 176
equal to zero.
(Figure B.3 on page
Section 3.2 ELECTRICAL INSTALLATION on page
for surface and flange mounting data. The inverter
for more details on the access to the control and
in order to allow air circulation
176) and provide an air deflecting
10).
Table B.5