WEG CFW701 User Manual page 31

Keypad (HMI) and Basic Programming
Inverter status:
LOC: local reference.
„
REM: remote reference.
„
: motor rotation according to the arrows.
„
CONF: configuration. It indicates that the inverter is in the Oriented Start-up routine or with
„
incompatible parameter programming. Refer section Incompatibility Between Parameters in
the programming manual of the CFW701.
SUB: DC link undervoltage.
„
RUN: inverter enabled and/or DC braking activated.
„
The keypad can be installed or removed from the inverter with or without AC power applied
to the inverter.
26 | CFW701
Monitoring Mode
It is the initial state of the keypad after power up and startup screen,
„
with the factory default values.
The Menu is not active in this mode.
„
Main display and secondary display show the values of the parameters
„
defined at P0205 and P0206.
From the monitoring mode, pressing the ENTER/MENU key will switch
„
to the programming mode.
Programming Mode
Level 1:
This is the first level of the programming mode. It is possible to chose
„
the parameter group by using the
The main display, secondary display and variable unit are not shown
„
at this level.
Press the ENTER/MENU key to go to the level 2 of programming mode
„
- parameters selection.
Press the BACK/ESC key to go back to the monitoring mode.
„
Level 2:
The parameter number is displayed on the main display and its value
„
on the secondary display.
Use the and keys to find the desired parameter.
„
Press the ENTER/MENU key to go to level 3 of the programming mode
„
– parameters value changing.
Press the BACK/ESC key to return to level 1 of the programming mode.
„
Level 3:
The parameter values is shown at the main display and the parameter
„
number at the secondary display.
Use the and keys to change the value of the selected parameter.
„
Press ENTER/MENU key to confirm the modification (save the new value)
„
or BACK/ESC key to cancel the modification (do not save the new value).
In both cases, the keypad returns to the level 2 of the programming mode.
Figure 4.3: Keypad operation modes
and keys.