Installing Your Tandberg Dlt Vs160 Tabletop Drive; Installation Overview - Tandberg Data DLT VS160 Installation And Operation Manual

Tandberg Data
install an internal drive in the computer you have chosen to
house the DLT VS160.
If you are installing a DLT VS160 Internal Drive, refer to page
2-9 for instructions.
2.3 Installing your Tandberg DLT
VS160 Tabletop Drive
This section contains step-by-step instructions for installing
your DLT VS160 Tabletop Drive.
2.3.1

Installation Overview

Installing your DLT VS160 Tabletop Drive is fast and easy
when you follow the instructions in this section in the order
presented. Installing your DLT VS160 Tabletop Drive consists
of the following steps, covered in the next few sections:
1. Unpack and check your drive for shipping damage.
2. Select a location near the server or workstation that is to be
the host for your DLT VS160 Tabletop Drive.
3. Set the SCSI ID for your DLT VS160 Tabletop Drive, if
necessary.
4. Shut down and turn off the server or workstation that is to
host your DLT VS160 Tabletop Drive. Remove the power
cable from the selected server or workstation. Turn off and
remove the power cables from all devices attached to the
selected server or workstation.
5. Install an LVD/SE SCSI host adapter in the server or
workstation that is to be the host for your drive, if
necessary.
6. Attach the SCSI cable to your DLT VS160 Tabletop Drive
and SCSI host adapter.
7. Install the terminator on your DLT VS160 Tabletop Drive if
it is the last or only device on the SCSI bus.
8. Attach the power cable to your DLT VS160 Tabletop Drive,
server or workstation, and all attached devices, plug in the
power cable to the nearest power outlet, and turn on all
devices.
9. Check your DLT VS160 Tabletop Drive to make sure it is
working properly.
2-2 Tandberg DLT VS160 Installation and Operations Manual
Installing Your Tandberg DLT VS160 Drive