Tape Drive Installation; Scsi Controller Board Installation - Tandberg Data SLRTAPEDRIVE Installation And User Manual

Tandberg SLR Installation and User's Guide

Tape Drive Installation

SCSI Controller Board Installation

All Tandberg Data SLR tape drives uses a SCSI interface to the
host system.
Before any SCSI device can be installed it is necessary to have a
SCSI controller board installed. Please pay attention to the
following points.
• Make sure your computer is turn off before proceeding to the
installation.
• If you computer is equipped with an onboard SCSI
controller, before proceeding with the installation, you
must first locate the SCSI connector on the computer
motherboard.
• Refer to the documentation provided with your computer to
find out where this connector is located.
• If multiple SCSI connectors are available, you can choose any of
them, except if your computer documentation mentions
something different.
· When done, firmly connect the SCSI connector to the Main-
board connector and refer to the section
to install your internal SLR.
Drive
• If your PC/Server needs a separate SCSI controller, you need
to make sure it is properly installed before connecting your
SLR tape drive.
Tandberg Data
Mounting the Tape
9