Hitachi Hidic EH-150 Applications Manual page 25

Preliminary Rev.03
No Name
Task code port information
1) Task code port
timeout
2) Timeout value
Task code port [1:4]
3-1) Protocol
4-1) Port No.
5) Set Button
6) Clear Button
The check of the set value will be started after clicking the "Set" button 5) on the window. If the value are
correct, these values are saved into setup file of this module and the frame changes to "Task code setting
window". If there is a error in the value, the error code will be shown in error window and setup file is not
changed. Please correct the value and set again.
To cancel the input value, please push the "Return" button of Web browser. The frame will return to the "Task
code display frame".
The contents of this manual might be changed without notice.
Chapter 5 Configuration and procedure for starting communication
Table 5.8 The list of items of Task code operation frame
To set the timeout of Task code connection is enable or not. This value is
valid for all Task code connections. If this is specified as disable, the
value of item (2) is not valid.
To set the value for timeout of Task code connection and this unit is
second. This value is valid for all Task code connections.
To select the protocol for Task code connection.
To set the logical port number for Task code connection.
To check and save the value into setup file.
To clear the items for setting.
Description
5-9
Range for setting
Enable, Disable
Between 0 and 65535
TCP/IP, UDP/IP
Between 1 and 65535