Hitachi Hidic EH-150 Applications Manual page 35

Preliminary Rev.03
The check of the set value will be started after clicking the "Set" button (A) on the window. If the value are
correct, these values are saved into setup file and the window changes to "Automatically Sending and
Receiving information display window". If there is an error in the value, the error code is displayed onto the
error window. Please correct the value and set again according to the error information.
5.5.2 The configuration of Automatically Sending and Receiving connection
The procedure of setting for Automatically Sending and Receiving connection
(1) Displaying of "Automatically Sending and Receiving connection display window"
Firstly, select the "Connection (1)-(6) link selection" of menu window then the operation frame changes to the
"Automatically Sending and Receiving connection display window". The current configuration is displayed
onto this window. This window is shown in figure 5.5.3.
Figure 5.5.3 Automatically Sending and Receiving connection display window
(2) Displaying of "Automatically Sending and Receiving connection configuration window"
Secondly, select the "Setting link selection" of "Automatically Sending and Receiving connection display
window" then the operation frame changes to the "Automatically Sending and Receiving connection
configuration window". This window is shown in figure 5.5.4. And the items which can be set by this
configuration window are also shown in table 5.6.
Figure 5.5.4 Automatically Sending and Receiving connection configuration window
The contents of this manual might be changed without notice.
Chapter 5 Configuration and procedure for starting communication
5-19