Table of Contents
Advertisement
Smart Connect Multi-loop Installation Manual
Zone Monitor Module (ZMM) +
Zone Monitor Module (ZMM) -
Network Module (NM) terminal A
Network Module (NM) terminal B
Multi-Relay Module (RM) NO
Multi-Relay Module (RM) CM
Multi-Relay Module (RM) NC
*In quiescent condition, the ACM has a reverse voltage on its terminals. So that a ground fault to ACM + will cause a negative ground
fault, and a ground fault to ACM - will cause a negative ground fault. When active, the impedance levels, and the fault messages
reverse.
www.zetaalarmsystems.com
10kΩ
10kΩ
N/A (Isolated from system voltage)
N/A (Isolated from system voltage)
N/A (Isolated from system voltage)
N/A (Isolated from system voltage)
N/A (Isolated from system voltage)
47
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SMARTCONNECT SMART6 and is the answer not in the manual?
Questions and answers
How to identify double address detector
To identify a double address detector in the Zeta Alarm Systems SMARTCONNECT SMART6, check the DIP switch address settings. A double address detector will respond to two consecutive addresses. If two detectors are configured with the same DIP switch settings or respond to the same address, this indicates a double address condition. Use the DIP switch table to verify that each detector has a unique address.
This answer is automatically generated