Advertisement
Troubleshooting
5) When unfolding vertical upper auger to unload, it is slamming down hard.
A) Unfold vertical upper auger all the way.
B) There is a bleeder screw on the vertical upper auger on the rod end of the cylinder. Crack open the
screw just a little to let the air bubbles out.
C) Close bleed screw tightly.
D) You might have to fold and unfold vertical upper auger a couple of times to push all the air out.
E) If auger is still slamming down hard, call Balzer's Service Department at 1-800-795-8551 extension
134 or 0 for the operator.
6) Joystick will not work.
A) Check and make sure that you have a minimum of 11 volts at all times.
Some tractors with a lot of electrical devices turned on at the same time may
run a little low on voltage. Try turning off un-needed devices to obtain the
NOTE
minimum voltage level.
B) If joystick is still not working, call Balzer's Service Department at 1-800-795-8551 extension 134 or
0 for the operator.
72
Advertisement
