Advertisement
Lubrication & Maintenance
E) Coupling the implement input driveline
(Figures. E1—E3)
Clean and grease the PTO and implement input
connection (II C)
AS-Lock
1. Pull locking collar and simultaneously push
implement input driveline onto PTO shaft until
the locking device engages.
QD Pin-Lock
2. Press QD pin and simultaneously push
implement input driveline onto PTO shaft until
pin engages.
Push-Pull Lock
3. Pull Locking collar and simultaneously push
implement input driveline onto PTO shaft until
the locking device engages
Check to insure all the locks are
securely engaged before starting work
with the implement input driveline.
F)
Check the length of the telescoping
members to insure the driveline will not
bottom out or separate when turning and/or
going over rough terrain.
Length modification of the implement input driveline
should only be done at the direction of the implement
manufacturer!
PTO Maintenance
G) Chains (Figure G1 - G3)
Note: The chain is intended to prevent the guard
from rotating against non-moving parts and thereby
reducing the likelihood of damage. A properly
installed chain will increase the service life of the
guard when properly maintained.
1. Chains must be attached to allow sufficient
articulation of the shaft in all working positions.
Care must be taken to be sure that chain does
not become entangled with drawbar hitch or
other restrictions during operation or transport
of machine.
2. The chain is not designed to carry the weight of
the implement input driveline. Damage will
occur if suspended by chain.
56
Advertisement
