Advertisement
Safety
SAFETY SIGNS ARE IMPORTANT
Safety signs or decals provide very important in-
formation and instructions designed to alert you to
dangers and hazards that can be present during op-
eration of this equipment. However, safety sign
instructions must be read, understood and followed
to be effective.
REPLACEMENT OF SAFETY SIGNS
Safety signs or decals must be kept clean and read-
able. If they become unreadable for any reason,
they must be replaced with an identical replace-
ment decal. Safety decals must also be replaced if
parts are repaired or replaced with new parts that
do not already include the necessary safety decals.
APPLICATION OF SAFETY DECALS
Surface preparation is very important for safety
decals to properly adhere. Grease, oil and dirt must
be removed and the surface must be smooth and
dry.
Most decals have a split backing which is meant to
be removed from the split outward. To apply the
decals follow these procedures:
1. Position the decal in the proper location and
hold firmly over the largest portion of backing.
2. Use one hand to hold the decal in position, with
the other hand carefully roll the loose end over and
peel the backing outward. When the backing is
removed as described and shown (Fig. 1), with
even and gradual pulling, the decal will roll onto
the surface smooth and wrinkle free.
3. With the smallest portion of the decal attached,
the same procedure can be applied to the other
half.
4. When the decal has been attached in place, use
a cloth or soft paper towel to burnish the decal
onto the cleaned surface. Work gently from the
middle outwards to avoid creating any wrinkles.
REPLACEMENT DECALS
Order replacement decals by part number through
your nearest dealer. Part numbers are printed on
each decal.
14
Fig. 1
Advertisement
