Lubrication & Maintenance
N) Assembly: Wide-angle implement input
driveline guard (Figures. N1 - N9)
1. Grease yoke groove and inner profile tube.
2. Fit bearing ring in groove with recesses
facing profile tube.
3. Slip on half-guard.
4. Turn cone until it engages correctly.
5. Tighten locking screw.
6. Grease bearing groove in double yoke.
7. Insert bearing ring.
8. Slide guard cone for double yoke over cam
from the connecting end. Make sure that
holes for screws are visible in the recesses.
9. Tighten locking screws.
PTO Maintenance
59