Advertisement
Lubrication & Maintenance
Steering Lubrication Independent Cross Axle
There is one (1) grease fitting located on each kingpin.
There is one (1) grease fitting located at each end of the tie rod.
To grease the hinge kingpins, it is best to have the wheels steering straight one time, to the left the next
time and finally to the right. This process insures that grease is getting to all areas of the kingpin.
Grease each location until new grease can be seen being pushed out.
The kingpin and tie rod requires grease every 4 hours the unit is in operation.
Proper steering is dependent upon adequate greasing.
When conditions are dry and dusty, the kingpins and tie rods will require grease more often.
Grease Fittings
NOTE
Grease thoroughly after pressure washing near kingpins.
61
Advertisement
