Advertisement
Operation
Instructions for Unloading Grain Cart
Visually become aware of which joystick switches control each of the functions
NOTE
on the grain cart. Views located on next page.
CAUTION
CAUTION
1. Engage tractor hydraulic to feed in the right direction.
2. Engage joystick control to un-fold upper auger until upper auger locks into place.
3. Start PTO slowly and use maximum modulation on tractor control.
4. Pull joystick trigger that controls the clutch to engage cross auger.
5. Allow PTO to get up to speed.
6. Incrementally engage joystick control that opens grain doors to percentage shown on joystick.
(20%, 40%, 60%, 80% or Fully Open)
7. When unloading is complete, engage joystick control that closes grain doors.
8. Allow PTO to run to clean out the augers.
9. Pull joystick trigger that controls the clutch to disengage cross auger.
10. Disengage PTO.
CAUTION
11.Engage joystick control to fold upper auger down into saddle.
12. Reload grain cart.
WARNING
Never transport with vertical auger in unloading position. Doing so
may cause structural damage to the vertical auger and grain cart.
Always maintain safe distance when unfolding vertical auger near
power lines.
Do not disengage PTO before clutch has been shut off. This may plug
auger with too much grain and you will not be able to restart auger.
Failure to disengage the clutch prior to shutting down the tractor can
cause a failure of the swivel fitting. Trapped oil in the clutch circuit
can expand due to warm temperatures, causing the swivel fitting to
fail.
44
Advertisement
