Advertisement
Lubrication & Maintenance
A) Only use a completely guarded drive system:
PTO drive systems with complete guarding, include
the tractor master shield (7), the implement input
driveline guard (4 - 6) and the implement shielding
(8) and must be installed at all times
If any component of the guarding system has been
removed for any reason, it must be replaced or
repaired prior to operation of the machine.
1. Quick-release end yoke
2. Overload and overrunning
clutches
3. Inner and outer sliding profiles
4. Inner and outer guard tubes
5. Guard cone
6. 1 chain, 2 chains
(depending on design)
7. Tractor master shield
8. Implement safety shield
PTO Maintenance
D) Lubrication (Figures D1 - D6)
work and every 8 operating hours. Clean and grease
the implement input driveline before each
prolonged period of non-use.
Molded nipples on the guard near each guard
bearing are intended as grease fittings and should
be lubricated every 8 hours of operation!
Telescoping members must have lubrication to
operate successfully regardless whether a grease
Implement
fitting is provided for that purpose! Telescoping
input
members without fittings should be pulled apart
driveline
and grease should be added manually.
* Check and grease the guard tubes in winter to
prevent freezing.
Complete
implement input
driveline guard SC
55
Lubricate with quality grease before starting
Advertisement
