Advertisement
Lubrication & Maintenance
L) To assemble cone:
1. Disassemble guard (Figures. J1 - J3). Remove
old cone (e.g. cut open with knife) Take off
chain. Place neck of new cone in hot water
approx 80°C / 180° F) and pull onto bearing
housing (Figure. L1)
2. Turn guard cone into assembly position (Figure.
L2). Further assembly instructions for guard
(Figures. K1 - K5).
3. Reconnect chain if required (Figure. L3).
PTO Maintenance
M) Disassembly: Wide-angle implement input
driveline guard (Figures. M1 – M7)
1. Remove locking screws
2. Remove double yoke guard cone.
3. Remove bearing ring
4. Remove locking screw.
5. Turn cone to assembly position.
6. Remove half-guard.
7. Remove bearing ring.
58
Advertisement
