Blackmagicdesign Videohub Installation And Operation Manual page 68

XY Controller Configuration
1 Drag the Number of Destinations slider to the desired number.
2 You can now configure the destination buttons by clicking on each gold button in the
software interface. In the Router SDI Out A field, enter the number of the Videohub
output port to which the destination device is connected. For dual link SDI destinations
you will need to enter port numbers for fields A and B, or fields A through D for quad
link SDI. There is also a Router Remote field if your Videohub is also routing RS-422
deck control to the destination device.
3 Click OK to confirm. If you increase the number of destination buttons, there will be a
matching decrease in the number of available source buttons.
4 Click on each white button in the software interface to configure the source buttons.
5 In the Router SDI In A field, enter the number of the Videohub input port to which
the source device is connected. For dual link SDI destinations you will need to enter
port numbers for fields A and B, or fields A through D for quad link SDI. There is also
a Router Remote field if your Videohub is also routing RS-422 deck control from the
source device.
6 Click OK to confirm.
Number of Macros
Macros allow you to make up to 16 crosspoint routing changes simultaneously with a single
button press.
1 Drag the Number of Macros slider to enable up to 10 macro buttons. As you increase
the number of macro buttons, there will be a matching decrease in the number of
available source buttons.
2 Click a green macro button to reveal the corresponding Macro window and enter up to
16 pairs of sources and destinations.
3 When finished, click OK to save the routes and close the window.
Up to 16 crosspoint routes can be changed by a single macro.
Blackmagic Videohub Software 68