Blackmagic Videohub Setup - Blackmagicdesign Videohub Installation And Operation Manual

The Blackmagic Videohub folder contains three Videohub applications. Videohub
Control, Videohub Setup, and Videohub Hardware Panel Setup.

Blackmagic Videohub Setup

Blackmagic Videohub Setup is an administration utility used to configure your Videohub,
customize your input and output labels, name your Videohub, and adjust the network settings,
and more.
NOTE After installing the Blackmagic Videohub software, the Videohub Server is also
automatically installed.
Network Settings
If your Videohub connects to a network via Ethernet, you can use Blackmagic Videohub Setup
to set the IP address.
Connect the Videohub to your computer via USB and follow these steps:
1 Launch Blackmagic Videohub Setup and it will automatically display any Videohubs that
are connected to your network.
2 If you have multiple Videohubs you can use the left and right arrows to cycle through
the devices.
3 Select your Videohub by clicking on either the picture or the configuration icon.
4 Click on the Configure tab and entre the IP address and also the Subnet Mask and
Gateway addresses if required.
5 Click the 'save' button to close the window and apply your changes. Click 'cancel' to
discard any changes.
TIP If your Videohub has a front panel LCD, you can use the front control panel to
select your IP address. See Configuring Network Settings with a Built In Control Panel
earlier in this manual for more information.
Blackmagic Videohub Software 47