Blackmagicdesign Videohub Installation And Operation Manual page 12

To select between cut bus and take button modes:
1 Press the 'menu' button to open the settings menu and use the rotary knob to select
the 'use take' setting. Press the 'take' button to confirm the selection.
2 Using the rotary knob, select 'on'. This sets your Videohub to use the take button to
confirm routing changes. To select cut bus mode, select 'off'. This means when you
select a source, it will be immediately routed without needing confirmation via the
take button.
3 Press 'take' to confirm the settings change. Press the 'menu' button to return to your
source and destination status.
The LCD provides instant confirmation of route selections
and changes and allows you to preview source and
destination video without an external monitor.
The Smart Videohub menu screen above shows the 'use
take' setting set to 'off'. This enables cut bus routing which
lets you bypass the take button and route your sources
instantly using the source buttons or rotary knob.
Locking and unlocking routes on Smart Videohub
Locking and unlocking routes with your Blackmagic Smart Videohub can be done easily using
the integrated front panel.
To lock a Destination
1 Press the 'dest' button
2 Hold the 'dest' button for 2 seconds. A padlock will appear next to the label to indicate
that the destination is now locked.
To unlock a Destination
1 Press the 'dest' button
2 Hold the 'dest' button for 2 seconds. The padlock will disappear from the label bar,
which indicates that the destination is now unlocked.
If a locked destination is selected, the 'src' button will no longer select a source.
Smart Videohub Control Panel 12