E360 Low Engine Oil Pressure - Perkins 1106D Troubleshooting Manual

SENR9982

E360 Low Engine Oil Pressure

Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects a
problem with the engine's oil pressure. The ECM
detects the following problems:
•
The engine has been running for more than ten
seconds.
•
The low oil pressure trip is below the trip levels for
the event code. Refer to Table 50 for a list of low
oil pressure trip levels.
•
Event code 100-03 Engine Oil Pressure open/short
to +batt is not active.
•
Event code 100-04 Engine Oil Pressure short to
ground is not active.
Note: This event code represents an event. This
does not represent an electronic system fault.
Table 50
Trip level
Delay to activation
System Response:
The event code will be logged.
The optional warning lamp will be illuminated.
Possible Performance Effect:
E360-1
None
E360-3
i02411185
Low Oil Pressure Trip Level (kPa Gauge) Table
E360-1
RPM kPa Gauge
0 0
700 100 kPa (14 psi)
900 150 kPa (21 psi)
1000 175 kPa (25 psi)
1200 200 kPa (29 psi)
1400 250 kPa (36 psi)
2500 250 kPa (36 psi)
8 seconds
RPM
0
700
1200
1800
2500
A snapshot will be triggered. The ECM will derate
the power. The power will be derated at seventeen
percent per second for two seconds.
The shutdown of the engine will only occur if
the "Enable Shutdown" customer programmable
parameter has been enabled.
Troubleshooting:
Refer to Troubleshooting, "Low Engine Oil Pressure".
Results:
•
OK – STOP.
107
Troubleshooting Section
E360-3
kPa Gauge
0
50 kPa (7 psi)
100 kPa (14 psi)
100 kPa (14 psi)
100 kPa (14 psi)
4 seconds