Perkins 1106D Troubleshooting Manual page 120

120
Troubleshooting Section
The sensor senses the speed requirement from the
throttle position. A second sensor may override this
speed requirement from the first sensor. This override
will be subject to an input from either the SAE J1939
(CAN), or from the PTO controls. Use the Perkins
Electronic Service Tool (EST) in order to check the
input status.
Use the Perkins EST in order to check the input
status.
Table 57
P1 Pin Connections
Function Throttle 1
+5 Volt Supply
Sensor Ground
Throttle Position
Input
Idle Validation
Illustration 22
Schematic of the analog throttle demand sensors
Throttle 2
41 42
33 34
54 55
45 44
SENR9982
g01207269