Perkins 1106D Troubleshooting Manual page 36

36
Troubleshooting Section
Input 4, Input 3, Input 2, Input 1
The number of these non-programmable parameters
that are visible depends on the value that is
programmed into the "Number of Switch Inputs"
parameter. "Open" signifies that the switch is in the
OFF position. "Ground" signifies that the switch is
in the ON position.
Physical Position Enabled
If "Yes" is selected from the drop-down menu, the
Electronic Control Module (ECM) sets the engine
rpm to the value that is programmed into the "Engine
Speed" for the configuration of the switches that is
defined for that Physical Position.
Table 28
Value
No
Yes
Logical Position
The Logical Position is the order that is required by
the user for a unique Physical Position.
Table 29
Range
1 to 16
Engine Speed (in RPM)
The "Engine Speed" is the programmed engine rpm
for a particular position of the multi-position throttle
switch.
If the ECM detects a switch combination that
has been configured as "No", a fault code will be
generated. In this situation, the ECM will ignore the
multi-position switch until the keyswitch is cycled
through OFF and ON.
Table 30
Range
Programmed Low Idle to
Programmed High Idle
Default
No
Default
1
Default
0
SENR9982