Perkins 1106D Troubleshooting Manual page 116

116
Troubleshooting Section
Illustration 21
Typical example of the schematic for the P1 OEM connections for the analog throttle demand sensors
Test Step 1. Check for Connector Damage
A. Turn the keyswitch to the OFF position.
B. Check the connectors and the harness for the
following faults:
•
Damage
•
Abrasion
•
Corrosion
•
Incorrect attachment
C. Refer to Troubleshooting, "Electrical Connectors
- Inspect".
D. Perform a 45 N (10 lb) pull test on each of the
wires in the harness that are associated with
the throttle demand sensor. Check the wire
connectors at the following positions:
•
ECM
•
Pressure sensors
•
Throttle pedal
The wire connectors are shown in table 55 and
table 56.
E. Check the screws for the ECM connectors for the
correct torque of 5.0 N·m (44 lb in).
Expected Result:
The connectors and the harness should be free of
the following faults: damage, abrasion, corrosion,
and incorrect attachment.
Results:
•
OK – Proceed to Test Step 2.
•
Not OK
Repair: Repair the connectors or the harness
and/or replace the connectors or the harness.
Verify that the repair eliminates the fault.
STOP.
Test Step 2. Check for Active Diagnostic
Codes
A. Connect the Perkins Electronic Service Tool (EST)
to the diagnostic connector.
SENR9982
g01207436