Transfer Of Knx Bus State - Siemens LOGO! CMK2000 Operating Instructions Manual

Configuring and commissioning using ETS
8.7 Data transfer KNX to LOGO!
8.7.5

Transfer of KNX bus state

If the special function "KNX bus state" is configured, the current KNX bus state is transferred
directly to the LOGO!. This means that the value is "1" if communication to KNX is OK. The
value is "0" if an error has occurred.
Note
• It may be the case that an error on the KNX bus is only detected following a delay of
several seconds.
• The last transferred KNX bus state is retained in the event of loss of the Ethernet
connection.
Image 8-23
KNX data type / LOGO! data type
KNX data type
1 bit - KNX bus state
72
KNX to LOGO! bus state
LOGO! data type
1-byte variable memory
•
Digital flag M (default)
•
Operating Instructions, 11/2015, A5E34877550B/001
CMK2000