Siemens LOGO! CMK2000 Operating Instructions Manual page 30

Installing/mounting
5.1 Installing the CMK2000
Mounting on a control panel / wall
Proceed as follows:
1. Move the sliders
2. The dimensions for the holes are shown in the following picture. Hole for M4 screw,
tightening torque 0.8 Nm to 1.2 Nm.
Image 5-2
NOTICE
If the CMK2000 is not mounted on the wall, the mounting sliders must always be left in the
factory-set positions, i.e. within the range shown in the above picture. Otherwise the
mounting sliders could become deformed if they are exposed to hot and moist ambient
conditions for a longer period of time.
30
①
to the outside until they latch in place.
CMK2000 wall mounting
Operating Instructions, 11/2015, A5E34877550B/001
CMK2000