Table of Contents
Advertisement
Interfaces
6–8
Repeater GBIT
6.5
Keyboard connector
The use of the Gigabit repeater extends the reach of required connections
between the IPC300 and CPS21T (LCD and X33) by 15 m per repeater, to a
maximum of 75 meters achieved with 4 repeaters. Installs via M4 press in
nuts. Using standard mounting clamps, snap on installation on a standard
DIN rail is also possible.
Refer to ordering information in Section 8.2.
GBIT_IN
X33
If necessary, display resolution must be set at 1024 x 768 Pixel in the repea-
ter from the DIP switch S1 (refer to the following illustration).
To change display resolutions, switches 1 through 8 on the S1 DIP switch
accessible in the housing can be set as follows:
D 1024 x 768 pixels
S1
(Repeater)
KBD
PS/2 mini DIN keyboard connector
A keyboard with PS/2 mini DIN connector can be connected to this port.
CAUTION
An external keyboard is to be connected at the "KBD" interface of the
CPS21T when the control panel is connected to a IPC 300. No keybo-
ard may then be connected at the interface "Keyb" of the IPC 300.
Otherwise, the keyboard signals may be faulty even if only one key-
board is used.
94.5
GBIT_OUT
Press in nut
M4 (2x)
X11
112
ON
OFF
1 2 3 4 5 6 7 8
27
(factory setting
in repeater)
1070 073 826-101 (01.10) GB
Advertisement
Table of Contents
