VPC i2 MICRO iCON User Manual page 5

i2 MICRO iCON USER'S MANUAL: SECTION 3
TOOLS REQUIRED
Phillips Head Screwdriver
MOUNTING INSTRUCTIONS
1. Prepare the mounting surface using the dimensions
provided in Figure A.
2. Attach the i2 Micro iCon receiver to the panel with
the provided 2-56 Phillips head screws and nuts
(Figure B). Torque screws to 2 in-lbs [0.23 Nm].
NOTE: If the mounting surface is thicker than 0.125" [3.18
mm], longer screws may be needed.
NOTE: If the mounting surface has threaded holes, the
nuts will not be needed.
NOTE: M2 hardware can be used in place of the pro-
vided 2-56 hardware.
NOTE: The dimensions shown reflect using a laser
5
cutting or punch press process. If using conventional
machining processes the 3.49" [88.65] dimension will be
3.69" [93.73] and a .09" [2.29] radius needs to be added
to the corners.
3-1
i2 MICRO iCON RECEIVER MOUNTING
PART # 310 130 XXX
For the most current information available, visit www.vpc.com
VIRGINIA PANEL CORPORATION
16.26
.640 TYP.
1.27
.050 TYP.
5.7
.23
100.07
3.940
88.6
5
3.49
5 TYP.
4.8
.19 TYP.
PART NUMBER
410130101
410130104
TOLERANCES ARE:
.XX = [.25].01
410130106
.XXX = [.13] .005
UNLESS OTHERWISE SPECIFIED
410130115
4 SEE TABLE 1 FOR MINIMUM DISTANCE OF SUBSEQUENT SIDE BY SIDE CUTOUTS.
*SPACING IS APPLICATION SPECIFIC, .80" MINIMUM, 1.00" RECOMMENDED
Figure A. Recommended panel cutout.
Figure B. If metric hardware is preferred, the supplied 2-56
hardware can be replaced with M2 hardware.
4
FOR MOUNTING PLATES .09" THICK OR LESS
.100 THRU, TYP. 4 PLCS
FOR MOUNTING PLATES THICKER THAN .09"
.086-56UNC-2B THRU, TYP. 4 PLCS.
2.3
R.09 TYP.
9.1
.36 TYP.
18.8
.74
TABLE 1
RECEIVER CUTOUT
DESCRIPTION
SPACING
ITA, i2 Micro iCon, 168 Position 1.00 [25.40]
ITA, i2 Micro iCon, 120/12 Position Hybrid 1.00 [25.40]
ITA, i2 Micro iCon, 168 Position with
2.19[55.63]
Oversized Backshell
ITA, i2 Micro iCon, 120/12 Position Hybrid
2.19[55.63]
with Oversized Backshell
4/23/15