VPC i2 MICRO iCON User Manual page 18

i2 MICRO iCON USER'S MANUAL: SECTION 8
16.26
.640
1.78
.070
PIN A1
8.76
.345
33.02
1.300
1
13 EQ. SPCS.
@ [2.54] .100
49.53
1.950
100.08
3.940
Figure A. PCB layout for i2 receiver, Part # 310 130 101. Thru hole
and pad diameters are for VPC QuadraPaddle male Adapter
Contact, Part # 610 138 117. The size of these holes may be
different if a header from a different manufacturer is used.
Connector mounts this side.
Figure C. Twin male header.
NOTE: Figure C details 0.22" [5.59 mm]/0.45" [11.43 mm]
min/max engagement.
NOTE: Minimum spacer height = 0.24" + header carrier
height - panel thickness (if used).
Any additional height beyond this minimum must be
added to the header post limits shown in Figure C.
NOTE: Several manufacturers offer the twin male
header: Samtec, TE, MultiComp, Molex. The specific
part number required is dependant on the distance
the i2 will be located from the PCB, the thickness of the
PCB, and the plating type required.
8-3
i2 MICRO iCON STANDARD PCB LAYOUT
i2 RECEIVER • PART # 310 130 101
12.70
.500
5 EQ. SPCS.
@ [2.54] .100
1
RECOMMENDED PCB LAYOUT
CONNECTOR MOUNTS THIS SIDE
TOLERANCES ARE:
.XX = [.25].01
.XXX = [.13].005
UNLESS OTHERWISE SPECIFIED
1
.0021 LOCATION TOLERANCES
APPLIES TO PLATED THRU HOLES
PIN F1
0.94±0.08
.037±.003
PLATED THRU HOLE
TYP. 168 PLCS.
.060 PAD
TYP. 168 PLCS.
2.54
.100 THRU
0.22" [5.6 mm] /
0.45" [11.4 mm]
HEADER CARRIER HEIGHT
For the most current information available, visit www.vpc.com
Figure B. i2 receiver, Part # 310 130 101, loaded
with twin female contacts, Part # 610 138 200.
Twin male headers are used to connect the
female contacts to the PCB plated thru holes.
HEADER, .100" SPACING TWIN MALE
SOLDERED TO PCB CREATES A
SEPERABLE INTERFACE
i2 RECEIVER
Figure D. A PCB can be mounted directly to the back of an i2 receiver as
shown above. Four 2-56 or M2 screws are required to mount the receiver.
Spacers may be needed to prevent unwanted stress on the PCB.
VIRGINIA PANEL CORPORATION
PCB
SPACER (SEE NOTE)
4/23/15