VPC i2 MICRO iCON User Manual page 13

i2 MICRO iCON USER'S MANUAL: SECTION 7
i2 MICRO ICON ACCESSORIES ● RECEIVER PROTECTIVE COVER REPLACEMENT
INSTALLATION AND REMOVAL INSTRUCTIONS
1. Press the cover onto the receiver until the cover is held
firmly in place.
2. To remove, grasp both sides of the cover and pull
backwards with even force.
Figure B shows the protective cover with a 6" [152.4mm]
beaded chain lanyard securing the cover to the receiver on
a panel. This can be achieved using a pan head 2-56 screw
included with the receiver.
NOTE: Max temperature for protective cover is 40°C.
7-2
PART # 310 113 569
For the most current information available, visit www.vpc.com
Figure A. i2 Micro iCon receiver protective cover.
Figure B. The eyelet coupling can be used to attach the protective
cover to the receiver using the 2-56 screw on the cable clamp.
VIRGINIA PANEL CORPORATION
4/23/15